| |
Home > Installation > Hints and Help > nora® special tools
Special hints and tricks |
|
- Steel straight edge, 10 cm wide:
- Cutting seams.
- Helpful to mark border lines on the floor and on the wall when creating
skirtings / running coves with noraplan®. In this way there is an exact
demarcation between neopren and dispersion adhesive.
- For cutting the floorcovering to the wall side when creating skirtings / running coves with noraplan®.
- Profile cutter:
- For cutting inner and outer angles exactly.
- For cutting the nora® cushioned-edge profile H 9010 when creating skirtings /
running coves with noraplan®.
- Cutting stencil for mitre cuts:
- For cutting the corners with noraplan®.
- Narrow spatula:
- For melting off small produting parts of nora® hot welding rod.
- Compass:
- To transfer the measurement for cutting exactly nora® stairtreads.
- To transfer unevenness of walls to the flooring.
- Liquid wax:
- To apply liquid wax to seam areas before sealing the joints with the
nora® TH joint sealing compound.
- To wax the mixing spindle and adhesive spreader before working with
the nora® TH joint sealing compound.
- For cleaning of soiled nora® rubber floorcoverings and accessories.
- Smoothing spatula:
- For smoothing exactly the nora® TH joint sealing compound when fresh.
- Mixing spindle:
- For mixing thoroughly the nora® TH joint sealing compound.
- Self-adhesive copper tape:
- For fast, neat and efficient working.
- Less appearing in outlines.
- Fast-setting adhesive, e.g. SICOMET (Henkel company):
- For gluing the inner and outer stair angles.
- For small gluing working on afterwords.
- Hooked blade:
- To remove small stones or residues of levelling compounds underneath glued flooring. Cut open with the hooked blade, remove the residues and
glue the cut open flooring on with contact adhesive.
|
