|
Home > Maintenance > Cleaning Recommendations Standard recommendation for nora® floorcoverings with «nora cleanguard®» surface (without surface finish):
|
noraplan® al/el - floorcoverings
Initial Cleaning
|
|||
 
|
Please refer to important information. Use brooms, sweeping machines or vacuum cleaners to remove loose dirt.
|
|||
 
|
Dilute suitable cleaning product with water according to the cleaning schedule and distribute with single-disc cleaning machine with suitable red pad or suitable medium-hard brush (for profiled coverings), making sure the product is distributed evenly over the entire area.
|
|||
|
Allow the solution to act for about 15 minutes, then clean intensively with the single-disc machine.
|
|||
|
Use an aqua-vacuum cleaner to remove the dirty detergent solution. The surface of the floorcovering must be free of dirt residues.
|
|||
|
Thoroughly wipe with clean water and remove with the aqua-vacuum cleaner.
|
|||
|
Initial care
|
||||
|
Dilute a suitable wash polish with water according to the cleaning schedule and apply evenly with a fine cleaning mop.
|
|||
|
Polish the dried wash polish film with a suitable polishing pad or a suitable soft brush (for profiled floorcoverings).
| |||
|
Note: The use of a suitable emulsion/dispersion has proven particularly beneficial for the initial care of noraplan® stone with a structured surface as well as in areas with particularly heavy soiling. In this case, the initial clean should be carried out using a suitable green pad or a suitable hard brush. On electrically conductive floorcoverings, no emulsions/dispersions may be applied, which have a negative effect on the electrical properties of the floorcoverings.
|
||||
|
Regular Maintenance
|
||||
|
|
Manually:Good cleaning results are achieved by 2-stage mopping (2-mop system + twin mobile bucket) or also with a special 1-stage cleaning system with suitable wash polish agents.
|
|||
|
By machine: Automatic cleaning is suitable for large, unobstructed areas.
|
|||
|
noraplan® acoustic with footfall sound absorption underlay, not joined-sealed. |
||||
|
Initial cleaning and polishing is to be carried out using the spray-cleaner method only. Regular maintenance should only be carried out by wet mopping using a moist or prepared cloth or a well-wrung mop.
|
|||
|
Intensive intermediate cleaning
|
||||
|
If built up dirt can no longer be removed by regular maintenance, an intensive intermediate cleaning with a single-disc machine should be performed. The selection of cleaning agent depends on the level of contamination and the type of residues; therefore, please consult the cleaning agent manufacturers for suitable cleaning products, such as basic cleaning agents or intensive cleaning agents.
|
|||
|
|
||||
