|
Large dirt trap zones effectively reduce the dirt accumulation.
Sand, chippings, and sharp-edged objects may result in irreparable damage. During the construction phase, the floorcovering is to be protected using suitable protective material.
Initial cleaning must not be carried out before the adhesive bonding phase has elapsed, i.e. no earlier than 48 hours after completion of the installation of the floorcovering.
Use cleaning and care products from a correspondingly matched product range.
Do not use cleaning products with a pH value above 12.
Cleaning and care products must not have a negative influence on the electrical properties of the floorcovering.
Do not use grit brushes, brown/black pads.
Single disc cleaning machines for initial or basic cleaning procedure should not exceed 200 rpm.
The use of very high speed buffing machines should be avoided. These machines should not exceed 1,500 rpm.F or polishing, a sufficient polishing film is absolutely necessary.
Depending on the type of project/application, it may be appropriate to deviate from the standard recommendations and use products and procedures according to the recommendations of the cleaning agent manufacturers.To do so you must perform a sufficient number of your own in-house tests to find out whether the cleaning measures, agents and machines you intend to use meet the special requirements.
Any products and processes used may have no adverse effect on the floorcovering and its properties.
In areas exposed to heavy sunlight, an increased amount of the cleaning product is to be applied.
Further advice for cleaning noraplan® with «nora cleanguard® plus (with surface finish)» and norament® 986 cara/metro/luxor (with surface finish)
Do not use hard brushes, no blue/green/brown/black pads.
Polishing can improve the level of gloss finish to the surface.
Chair and furniture castors must be of type W (soft rollers) according to EN 12 529.
A mat under the chairs is recommended in the workplace. The contact area of
the chairs and other furniture must not have sharp edges and is to be sufficiently dimensioned. If necessary, the contact areas are to be protected using pressure distribution mats.
Restoration/Preservation of value: In case of any possible wear symptoms, we recommend restoring the surface in good time with a suitable permanent coating.
Please contact our technical department in this case.
|
