Important Information
- Sand, chippings, and sharp-edged objects may result in irreparable damage. During the construction phase, the floorcovering is to be protected using suitable protective material.
- Initial cleaning must not be carried out before the adhesive bonding phase has elapsed, i.e. no earlier than 48 hours after completion of the installation of the floorcovering.
- Use cleaning and care products from a correspondingly matched product range.
- Do not use cleaning products with a pH value above 12.
- Cleaning and care products must not have a negative influence on the electrical properties of the floorcovering.
- Do not use grit brushes, brown/black pads.
- Single disc cleaning machines for initial or basic cleaning procedure should not exceed 200 rpm.
- The use of very high speed buffing machines should be avoided. These machines should not exceed 1,500 rpm.F or polishing, a sufficient polishing film is absolutely necessary.
- Depending on the type of project/application, it may be appropriate to deviate from the standard recommendations and use products and procedures according to the recommendations of the cleaning agent manufacturers.To do so you must perform a sufficient number of your own in-house tests to find out whether the cleaning measures, agents and machines you intend to use meet the special requirements.
- Any products and processes used may have no adverse effect on the floorcovering and its properties.
- In areas exposed to heavy sunlight, an increased amount of the cleaning product is to be applied.