As per. VOB DIN 18 365, the surface must be level, permanently dry, dust-free, tension and compression-proof. Apply suitable dispersion primer to dusty surfaces. The surfaces may not have structure heights above 0.6 mm, if necessary, level out.

Fix nora® Profix to the wall using the supplied roll-off disc.

Clean back of the skirting with damp cloth, remove protective paper from installation band and attach the skirting at the correct height.

Rub the skirting into place with stair tool or hammer into place with a rubber mallet.

Outer corners:
Heat outer edges of skirting with a welding gun (figure 1)and pull around the corner using slight tension. Hold the outer corner angles until the skirting has cooled down (figure 2).

figure 1

figure 2

Inner corners:
Heat the skirting and press carefully into the corner with the stair tool, then hold until cooled down (figure 3). Alternatively, the inner corners may be cut and butt-jointed. In order to avoid formation of joints, the skirtings have to be bonded at the corner with super glue type.

figure 3

Joining:
Connections between 2 skirtings have to be bonded with super glue type on a hard surface to avoid joint formation (figures 4/5).

figure 4

figure 5

Fasten the skirting to the wall using a rubber mallet.